Free Shipping on continental US orders over $99.
Exclusions apply, click for details.
This 6 inch Pro Comp suspension kit provides excellent handling and proven replacement high strength extended steering knuckle design. Provides proper geometry for the steering, CV axles and other suspension components. All of these kits are 100% compatible with the factory Stabilitrak electronic stability control system. The one piece cross members install easily and keep everything aligned properly.
The deluxe kit GM169DX also retains the factory front coil over shocks uses a spacer on top of the factory coil over. Also included ES9000 rear shocks. This kit includes a CV type front drive shaft with different differential drop brackets to set teh driveshaft angle proper for the CV type driveshaft. This kit is compatible with Autotrac or can be used for high speed 4WD operation without causing the slight front driveshaft vibration.
|Important Notes||A few notes before ordering this system, you cannot run the factory wheels with these kits the backspacing on the factory wheels are too deep and will not clear the extended steering knuckle. Pro Comp recommends a 17 inch or larger wheel not to exceed 8 inch in width with a max of 5 inch backspacing. Additionally, a quality tire of radial design not exceeding 35 inch tall x 12.5 inch wide is also recommended. The use of a 35 inch x 12.5 inch tire will require minor trimming. These kits are not compatible with factory autoride systems. Jack-it offers other kits that will work with the autoride system if your vehicle is equipped with that option.|
|Lift Height||6 inch|
WARNING : Cancer and Reproductive Harm. www.p65warnings.ca.gov/